Eight of the control characters begin ISO/ANSI standard "control sequences" (or "escape sequences"). These sequences are described below and diagramed in Appendix C. G0 ::= (SP through DEL) G1 ::= (NBSP through "ÿ") ESC-Seq ::= ESC (SP through "/") * ("0" through "~") ShiftToG2 ::= SS2 G0 ShiftToG3 ::= SS3 G0 CSI-Seq ::= CSI (SP through "?") * ("@" through "~") DCS-Seq ::= (DCS | OSC | PM | APC) (SP through "~" | G1) * ST "ESC-Seq" is the control sequence ESC (hex 1B), followed by zero or more characters in the range SP through "/" (hex 20 through hex 2F), followed by a character in the range "0" through "~" (hex 30 through hex 7E). These sequences are reserved for future use and should be skipped by current FTXT reader programs. SS2 (hex 8E) and SS3 (hex 8F) shift the single following G0 character into yet-to-be-defined graphic sets G2 and G3, respectively. These sequences should not be used until the character sets G2 and G3 are standardized. A reader may simply skip the SS2 or SS3 (taking the following character as a corresponding G0 character) or replace the two-character sequence with a character like "?" to mean "absent". FTXT uses "CSI-Seq" control sequences to store character formatting (font selection by number, type face, and text size) and perhaps layout information (position and rotation). "CSI-Seq" control sequences start with CSI (the "control sequence introducer", hex 9B). Syntactically, the sequence includes zero or more characters in the range SP through "?" (hex 20 through hex 3F) and a concluding character in the range "@" through "~" (hex 40 through hex 7E). These sequences may be skipped by a minimal FTXT reader, i.e., one that ignores formatting information. Note: A future FTXT standardization document will explain the uses of CSI-Seq sequences for setting character face (light weight vs. medium vs. bold, italic vs. upright, height, pitch, position, and rotation). For now, consult the ISO/ANSI references. "DCS-Seq" is the control sequences starting with DCS (hex 90), OSC (hex 9D), PM (hex 9E), or APC (hex 9F), followed by zero or more characters each of which is in the range SP through "~" (hex 20 through hex 7E) or else a G1 character, and terminated by an ST (hex 9C). These sequences are reserved for future use and should be skipped by current FTXT reader programs.